Quick 706w+ SMD Rework station bit replacement
Turn Off and Unplug the Station: Ensure the rework station is turned off and unplugged from the power source to avoid any accidents.
Let It Cool Down: If the station has been used recently, allow it to cool down completely to prevent burns.
Remove the Old Bit:
Depending on the design, you may need to unscrew a small retaining screw or simply pull out the old bit. Consult the user manual for specific instructions related to your model.
If a screw is present, use the screwdriver to loosen and remove it.
Install the New Bit:
Insert the new bit into the appropriate slot. Ensure it fits securely.
If there was a screw, reattach and tighten it to hold the bit in place.
Check the Fit: Ensure the new bit is properly seated and secure. It should not wobble or come loose during operation.
Test the Station: Plug the rework station back in and turn it on. Test the new bit by heating it up to ensure it works correctly and heats evenly.
