DIY DANA 44 REAR PINION SEAL JEEP JKU HOW TO REPLACE
Leaking Pinion seal could be from wear and tear, bad pinion bearings or excessive vibration
: Dana 44 Rear Pinion Seal https://amzn.to/3peCC3w
: Dana 44 Crush Sleeve eliminator https://amzn.to/3o9ELOv
: Patreon https://www.patreon.com/user?u=271681...
: Beer Donations or Tomcat Treats https://paypal.me/bullshitkorner?loca...
The most important thing about changing a rear differential pinion seal is the pinion bearing preload. It's best to measure before you remove the nut so you can set it back up the way it was. However I rebuilt my Dana 44 and now using a Crush Sleeve Eliminator. Replacing the rear pinion seal isn't hard but care must be taken.
DISCLAIMER: Due to factors out of the control of Bullshitkorner and Bsk Garage, we cannot guarantee against improper use or unauthorized modifications of this information. Bullshitkorner and Bsk garage assumes no liability or responsibility for property damages or injury incurred as a result of any information contained in this video and all other videos produced by Bullshitkorner and Bsk Garage. Use this information at your own risk. Bullshitkorner and Bsk Garage recommends safe practices when working on vehicles and/or with tools seen in this video. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Bullshitkorner and Bsk Garage Be safe! This video and description contain affiliate links, which means that if you click on one of the product links, we receive a small commission. This helps support the channel and allows us to continue to make videos like this. Thank you for the support!
#Pinionsealdiy #leakingpinionseal #DIY
![Osake wa fufu ni natte kara [episode 12]](https://images.mixrolikus.cc/video/lkOwB-Fztfc)
