Dana 44 How to Rebuild | Jeep JKU DIY
With a Broken Pinion tooth I need to take apart the entire D44 Axle to Rebuild it.
: Slide Hammer https://amzn.to/3DbrnyI
: Gear Puller https://amzn.to/3F53JV6
You'll need to remove tires, brakes and caliper, drain differential fluid and pull cover. Use a slide hammer to pull axles. Make sure the carrier bearing caps are witnessed marked before removing them. Pull bearing caps and remove differential carrier. Remove driveshaft, pinion nut, pinion and rear pinion seal.
DISCLAIMER: Due to factors out of the control of Bullshitkorner and Bsk Garage, we cannot guarantee against improper use or unauthorized modifications of this information. Bullshitkorner and Bsk garage assumes no liability or responsibility for property damages or injury incurred as a result of any information contained in this video and all other videos produced by Bullshitkorner and Bsk Garage. Use this information at your own risk. Bullshitkorner and Bsk Garage recommends safe practices when working on vehicles and/or with tools seen in this video. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Bullshitkorner and Bsk Garage Be safe! This video and description contain affiliate links, which means that if you click on one of the product links, we receive a small commission. This helps support the channel and allows us to continue to make videos like this. Thank you for the support!
#D44Rebuild #Brokenpinontooth #JeepJKU
