ESP32 Cam || How to Setup Esp32 Cam for FDTI Programming Tutorial
The ESP32-CAM is a popular development board that integrates an ESP32 microcontroller and a camera module. It is often used for IoT projects, surveillance systems, and other applications that require both wireless connectivity and image capture capabilities.
To program the ESP32-CAM using an FTDI programmer, you will need to connect the programmer to the board's serial pins. The ESP32-CAM has six pins that are labeled as follows:
GND: Ground
5V: Power supply voltage (can be either 3.3V or 5V)
U0R: Receive pin for UART0
U0T: Transmit pin for UART0
IO0: Boot mode selection pin
To connect the FTDI programmer, you will need to connect the following pins:
FTDI GND to ESP32-CAM GND
FTDI VCC to ESP32-CAM 5V (or 3.3V, depending on your power supply voltage)
FTDI TX to ESP32-CAM U0R
FTDI RX to ESP32-CAM U0T
FTDI RTS to ESP32-CAM IO0
Once the connections are made, you can use a software tool such as the Arduino IDE or PlatformIO to program the ESP32-CAM using the FTDI programmer. You will need to select the correct board and serial port settings in the software, and then upload your code to the ESP32-CAM.
Our Website:-www.knowled.in
@arduino@esp32@esp32cam#esp#esp32cam
